[1]马立立,陶爱莲,刘善燕,等.轧制参数对高强度管线钢低温韧性和微观组织的影响[J].焊管,2018,41(3):63-68.[doi:10.19291/j.cnki.1001-3938.2018.03.013]
　Edited and Translated by MA Lili,TAO Ailian,LIU Shanyan,et al.Effect of Rolling Parameters on the Low-temperature Toughness and Microstructure of High-strength Linepipe Steel[J].,2018,41(3):63-68.[doi:10.19291/j.cnki.1001-3938.2018.03.013]
点击复制

轧制参数对高强度管线钢低温韧性
和微观组织的影响()
分享到：

《焊管》[ISSN:1001-3938/CN:61-1160/TE]

卷:
41
期数:
2018年第3期
页码:
63-68
栏目:
国外焊管
出版日期:
2018-03-28

文章信息/Info

Title:
Effect of Rolling Parameters on the Low-temperature Toughness and
 Microstructure of High-strength Linepipe Steel
文章编号:
10.19291/j.cnki.1001-3938.2018.03.013
作者:
马立立; 陶爱莲; 刘善燕; 吴 强 编译
 南京巨龙钢管有限公司， 南京 210061
Author(s):
Edited and Translated by MA Lili;  TAO Ailian;  LIU Shanyan;  WU Qiang
 Nanjing Julong Steel Pipe Co., Ltd., Nanjing 210061, China
关键词:
管线钢; 夏比冲击试验; 高强度; 落锤试验; 预应变; 轧制状态; 微观组织
Keywords:
pipeline steel; charpy test; high-strength; DWTT; pre-straining; as-rolled; microstructure
分类号:
TE973.1
DOI:
10.19291/j.cnki.1001-3938.2018.03.013
文献标志码:
A
摘要:
为了确保管道在极端环境下长期运行而不产生塑性断裂，选取了A、B两种高FRT（终轧温度）和CST（冷却停止温度）板材进行试验研究。试验结果表明，当温度在-20 ℃以下时，加载10%预应变会对板材夏比冲击功产生负作用，且A1、B1两种试验板材冲击功高于其他试验板材，B1的韧性优于A1，但两种试验板材在经轧制后其冲击功又可达到同一水平。对A、B两种试验板材采用预疲劳和开缺口进行了-20 ℃温度下落锤试验，由总能量和J积分值检测结果可见，两种类型试样的剪切面积均能保持在90%以上，可见，工业用厚壁钢板显示出了很好的韧性。微观组织结构研究表明，10%的预应变将会导致材料内部碳氮颗粒和非金属夹杂物附近形成空隙，由此而对材料的韧性造成影响，同时，其他因素也可能会引起板材预应变后冲击功的下降，比如在EBSD（电子背散射衍射）方法观察到的材料内部高取向差的区域，其在经预应变后冲击功将会出现明显的下降。
Abstract:
In order to ensure the long term operation of pipeline in extreme environment without producing plastic fracture, A sheet with final rolling temperature(FRT) and B sheet with cooling stop temperature(CST) were chose for experimental investigation. The results showed that below -20 ℃, loading 10% pre-strain would produce negative effects on sheet charpy impact, the impact energy of A1 test sheet and B1 test sheet were higher than that of other test sheets, the toughness of B1 test sheet was better than that of A1 test sheet, but the impact energy of them could reach the same level after rolling. A sheet and B sheet with pre-fatigue and notching were used for drop-weight test at -20 ℃, from the total energy and J integral value, the shear area of the two types of specimens remained above 90%. This proved the industrial thick wall steel plate showed good toughness. The research of microstructure indicated that 10% pre-strain would cause the gap near the non-metallic inclusions and particles of carbon and nitrogen in materials, which would affect the toughness of the material, other factors might also cause the decrease of the impact energy, as observed the material internal high misorientation region with the EBSD method, its impact energy after pre-strain would be significantly decreased.

相似文献/References:

[1]李新华,罗金恒,赵新伟,等.高钢级管线钢失效评估曲线研究[J].焊管,2007,30(4):33.[doi:1001－3938（2007）04－0033－03]
　LI Xin-hua,LUO Jin-heng,ZHAO Xin-wei,et al.Research on Failure Assessment Curves of High Grade Pipeline Steel[J].,2007,30(3):33.[doi:1001－3938（2007）04－0033－03]
[2]宫少涛,王爱民,吉玲康,等.X80与X100级管线钢屈服强度Rt 0.5与Rp 0.2的差异性研究[J].焊管,2007,30(5):42.[doi:1001－3938（2007）05－0042－03]
　GONG Shao-tao,WANG Ai-min,JI Ling-kang,et al.Study on Difference Between Yield Strength Rt 0.5 and Rp 0.2 for X80 and X100 Pipelines Steel[J].,2007,30(3):42.[doi:1001－3938（2007）05－0042－03]
[3]刘庆才,李 东,黎剑锋.影响输气管线钢管抗H2S性能主要因素的探讨[J].焊管,2007,30(5):54.[doi:1001－3938（2007）05－0054－05]
　LIU Qing-cai,LI Dong,LI Jian-feng.Key Factors Affecting Sour Service Ability of Welded Pipe and Its Domestic Production[J].,2007,30(3):54.[doi:1001－3938（2007）05－0054－05]
[4]王树人,崔志新.管线钢落锤撕裂试验异常脆性断口分析[J].焊管,2007,30(6):69.[doi:1001－3938（2007）06－0069－03]
　WANG Shu-ren? CUI Zhi-xin.Analysis on Abnormal Brittle Fracture of DWTT for Pipeline Steel[J].,2007,30(3):69.[doi:1001－3938（2007）06－0069－03]
[5]陶 鹏,张 弛,杨志刚,等.高钢级管线钢的组织和力学性能[J].焊管,2008,31(2):19.[doi:1001－3938（2008）02－0019－04]
　TAO Peng,ZHANG Chi,YANG Zhi-gang,et al.The Microstructure and Mechanical Property of X70,X80 and X100 Grade Pipeline Steel[J].,2008,31(3):19.[doi:1001－3938（2008）02－0019－04]
[6]黄明浩,徐 烽,黄国建.影响管线钢屈强比的因素探讨[J].焊管,2008,31(3):20.[doi:1001－3938（2008）03－0020－04]
　HUANG Ming-hao,XU Feng,HUANG Guo-jian.Discussion on Influencing Factors of Yield Ratio for Pipeline Steel[J].,2008,31(3):20.[doi:1001－3938（2008）03－0020－04]
[7]牛 辉,余大涛,高惠临.管线钢焊接热影响区的组织预测[J].焊管,2008,31(3):28.[doi:1001－3938（2008）03－0028－05]
　NU Hui,YU Da-tao,GAO Hui-lin.Structure Forecast of Pipeline Steel Welding Heat Affected Zone[J].,2008,31(3):28.[doi:1001－3938（2008）03－0028－05]
[8]孔君华,郑 琳,关 云,等.西气东输二线工程用18.4 mm厚 X80级热轧板卷生产实践[J].焊管,2008,31(6):50.[doi:1001－3938（2008）06－0050－04]
　KONG Jun-hua,ZHENG Ling,GUAN Yun,et al.Production Experience of X80 Grade Hot Rolled Coil with 18.4 mm Thickness Used〖JZ〗for the Second West to East Gas Pipeline Project[J].,2008,31(3):50.[doi:1001－3938（2008）06－0050－04]
[9]黄国建,张英慧,孔祥磊,等.特厚规格X70和X80级热轧卷板的开发与应用[J].焊管,2009,32(2):17.[doi:1001－3938（2009）02－0017-06]
　HUANG Guo-jian,ZHANG Ying-hui,KONG Xiang-lei,et al.Development and Application of X70 & X80 Grade HRC with Heavy Thickness[J].,2009,32(3):17.[doi:1001－3938（2009）02－0017-06]
[10]杨专钊,李云龙,邓波,等.管线钢拉伸试验中异常屈服强度研究与分析[J].焊管,2009,32(4):51.[doi:1001－3938（2009）04－0051－03]
　YANG Zhuan-zhao,LI Yun-long,DENG Bo,et al.Research and Analysis of Abnormal Yield Strength during Tensile Test of Pipeline Steel[J].,2009,32(3):51.[doi:1001－3938（2009）04－0051－03]

备注/Memo

备注/Memo:
收稿日期： 2017-11-22
作者简介： 马立立（1984—），女，学士学位，工程师，主要从事质量管理及理化试验工作。
更新日期/Last Update: 2018-04-18